Kling-freitag CON:SEQUENZA+K&F Manuel d'utilisateur télécharger pdf (Page 46)

User’s Guide K&F CON:SEQUENZA+

KLING & FREITAG GmbH Version 1.0 Seite 46 von 53

5 Advanced Features

This chapter goes into some features of CON:SEQUENZA+ that can be used to take full advantage

of its capabilities.

5.1 Setting Layout Pictures

Sometimes you may happen to have a plan drawing or an aerial picture available for your venue. In

this case you want to use the picture as a basis to draw your project on.

Click on the Layout Picture icon : a window will appear, and you will be asked for a path to

load your picture from. Once you have imported the picture, you will need to drag the points A

and B until they match an edge on the drawing whose length is known. Then enter the length;

you can also define the shift of the image, by entering the XY-location of point A in your project,

or set the opacity of the picture. When you click OK, you will be able to see the picture in Top

View, and to draw your venue on top of it.

The same is possible for the Side View: in this case you can load one layout picture for each

Audience Zone, by clicking on the icon in Side View when the zone is selected. If you have a

cross-section drawing of your venue, you can use it for that. In this case, you will be able to define

DZ-coordinates for point A (relative to the front edge of the zone, along its central axis).

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 52 53

Pas de commentaire

Kling-freitag CON:SEQUENZA+K&F Manuel d'utilisateur Page 46